We offer standard sizes and custom shapes because SIZE DOES MATTER!!
Whether it is with our standard NoSweat!™ Waterproof Liners or our custom NoSweat!™ Waterproof Liners you too can practice "safescape".
NoSweat!™ Liners are constructed like a water bed mattress using a patented RF welding process for seaming the liners. The process stresses strict control of power, pressure and dwell time to insure a perfect seam every time! The industry requires that seams have a tensile strength of no less than 70% of the vinyl being sealed.
Our standard liners are in stock and ready to ship. We carry 6 standard sizes; and each size fits cylinder pots best.
Custom liners come in both clear and tan vinyl and can be made to meet your specifications and measurements; liners usually ship out within 7-10 working days. We also offer custom NoSweat!™ Waterproof Liners with a loc-in bead at the top that can be used with our loc-in clamp for easy attaching.
Standard NoSweat!™ Waterproof Liners
Simply place right in your decorative planter pot.
When using for Caryotis Palms the manufacturer recommends "up potting" at least two sizes from the growing container and the use of two liners per plant.
Classic NoSweat!™ Waterproof Liners
Place right in your decorative planter pot, adhere to top with double stick tape, and cut away the excess.
Custom NoSweat!™ Waterproof Liners
Before ordering, measure each planter. NoSweat!™ Liners are constructed to the specification you provide. Do not rely on the architectural drawings as changes may occur during construction.
-Identify each corner on drawing with a letter. Measure each side and cross measure.
-If using drain rock use only round rock, no sharp or pointed aggregate is acceptable as this may damage/ puncture the liner.
-Below the liner, create a low spot for water collection and siphoning.
-Remove all foreign material from planter
-Clean and abrade all surfaces to receive adhesive.
-Remove all sharp edges, etc.found during inspection.
-Backfill planter with appropriate material.
-Use previous measurements and cut NoSweat!™ loc-in clamp to fit each side.
-Install clamp with one of the following:
-For Wood or Metal substrate: 1"8d ring shank nail (pre-drill clamp12-16" O.C.) or 1" #10 pan head sheet metal screw, pre-drill 12-16" O.C.
-For Concrete substrate: Apply epoxy to clean surface where clamp will be affixed.
-Mark planter at desired level on all sides so liner will hang square.
-If using epoxy, apply a serpentine bead on back of clamp and place. During cure hold clamp in place with duct tape.
-If using nails or screws, mark level as above
-Apply corner "A" of liner to corner "A" of planter and so on. Make sure to smooth wrinkles with clean hands as you go around the liner.