 |  |  |  |  |  |  |
Installation Procedure for Custom No Sweat! Waterproof Liner
Before ordering, measure each planter. No Sweat! Liners are constructed to the
specifications you provide. Do not rely on the architectural drawings as changes may occur
during construction.
Identify each corner on drawing with a letter. Measure each side and cross measurement
Install as per No Sweat! suggested specification instructions. If using drain rock use only
round rock, no sharp or pointed aggregate is acceptable as this may damage/puncture the
liner.
A. Below liner, create a low spot for water collection and siphoning.
B. Remove abundant irregularities.
C. Backfill with appropriate material.
Use previous measurements and cut No Sweat! Loc-in Clamp to fit each side.
Apply No Sweat! Loc-in Clamp as per instructions Section 3.03, A, 1, 2 & 3.
A. Mark Planter at desired level on all sides so liner will hang square.
B. If using epoxy, apply in a serpentine bead on back of clamp and place. During cur(follow
manufacturers recommendation), hold clamp in place with duct tape. e time
C. If using nails or screws, mark level as above.
D. Install liner
Apply corner “A” of liner to corner “A” of planter and so on. Make sure to smooth wrinkles
with hands as you go around liner.
Before ordering, measure each planter. No Sweat! Liners are constructed to the
specifications you provide. Do not rely on the architectural drawings as changes may occur
during construction.
Identify each corner on drawing with a letter. Measure each side and cross measurement
Install as per No Sweat! suggested specification instructions. If using drain rock use only
round rock, no sharp or pointed aggregate is acceptable as this may damage/puncture the
liner.
A. Below liner, create a low spot for water collection and siphoning.
B. Remove abundant irregularities.
C. Backfill with appropriate material.
Use previous measurements and cut No Sweat! Loc-in Clamp to fit each side.
Apply No Sweat! Loc-in Clamp as per instructions Section 3.03, A, 1, 2 & 3.
A. Mark Planter at desired level on all sides so liner will hang square.
B. If using epoxy, apply in a serpentine bead on back of clamp and place. During cur(follow
manufacturers recommendation), hold clamp in place with duct tape. e time
C. If using nails or screws, mark level as above.
D. Install liner
Apply corner “A” of liner to corner “A” of planter and so on. Make sure to smooth wrinkles
with hands as you go around liner.