Installation Procedure for Custom No Sweat! Waterproof LinerÔ

Before ordering, measure each planter. No Sweat! Liners are constructed to the specifications you provide. Do not rely on the architectural drawings as changes may occur during construction.

Identify each corner on drawing with a letter. Measure each side and cross measurement

Install as per No Sweat! suggested specification instructions. If using drain rock use only round rock, no sharp or pointed aggregate is acceptable as this may damage/puncture the liner.

 A.   Below liner, create a low spot for water collection and siphoning.

 B.   Remove abundant irregularities.

 C.  Backfill with appropriate material. 

Use previous measurements and cut No Sweat! Loc-in Clamp to fit each side.

Apply No Sweat! Loc-in Clamp as per instructions Section 3.03, A, 1, 2 & 3.

        A. Mark Planter at desired level on all sides so liner will hang square.

        B. If using epoxy, apply in a serpentine bead on back of clamp and place. During cur(follow manufacturers recommendation), hold clamp in place with duct tape. e time

       C. If using nails or screws, mark level as above.

       D.  Install liner

 Apply corner “A” of liner to corner “A” of planter and so on. Make sure to smooth wrinkles with    hands as you go around liner.